Replacing The Lamp; Troubleshooting - Zanussi ZOP67902XU User Manual

sure that after the installation the surface of the
glass panel frame (B) on the screen-printing zones
is not rough when you touch it.
A B C
Make sure that you install the middle panel of glass
in the seats correctly.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
A
resistant lamp.
4. Install the glass cover.
B
C
Possible cause
The oven is not connected to
an electrical supply or it is con-
nected incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is ac-
tivated.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-
off".
25