Netherlands. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. 5 3122 785 10160...
GB 4 FTV1.9EE Safety instructions, warnings and notes 2. Safety instructions, warnings and notes Safety instructions h positioned at right side of IR-receiver eye of the E-box. Take into account that receiver-LED on DST is positioned not in the middle but at the left side. Point corresponding It is not allowed to operate the FTV-set without glass plate.
GB 20 FTV1.9EE Mechanical instructions 4. Mechanical instructions Introduction: 4.1.1 SMALL SIGNAL panel (SSP). There are pre-defined service positions for the following panels: 1. SSP (copper side). 2. EURO/IO panel. 3. TXT panel. 4. FRONT/IO panel. 5. SUPPLY panel. 6. AV BUFFER panel.
Page 21
Mechanical instructions FTV1.9EE GB 21 4.1.4 FRONT/IO panel. EURO I/O CL96532069_125.EPS 090899 Figure 4-5 1. Remove the copper shielding from the antenna-input connector [1]. Front I/O Switch 2. After lifting the bracket from the SSP [2], it can be rotated CL96532069_127.EPS...
Page 22
GB 22 FTV1.9EE Mechanical instructions 4.1.6 AUDIO VIDEO BUFFER panel. NICAM Double Window AV-Buffer Feature Box CL96532069_129.EPS 090899 Figure 4-9 1. First remove the adjacent SUPPLY panel. This can be done by removing the 2 fixation screws [1] and lifting this panel from its bracket [2].
Service modes, fault finding and repair tips FTV1.9EE GB 23 5. Service modes, fault finding and repair tips The E-Box and the Monitor are separate devices, which can • provide a situation with predefined settings to get the same also be sold and serviced separately.
GB 24 FTV1.9EE Service modes, fault finding and repair tips Display Info D-box (8) General Menu Control -------------------------------------------------- The General Menu has another 7 menu-items of which White Explanation notes/references: Drive and Luminance Delay have several sub-items. (1) Date : dd-mm-yy •...
Page 25
Service modes, fault finding and repair tips FTV1.9EE GB 25 Id: F19DE11.0_12345 (1) 2. DNR Operation Hours: LLLLL (2) 3. Noise Figure Errors: 14 08 02 4. Colour System -------------------------------------------------- 5. TV System Software identification of the main micro controller (F19DBC 6.
Page 26
Introduction • +33 V (SSP-frontend, DW) : 40 V To trouble shoot the E-box Supply, first check the LED of the ComPair (Computer Aided Repair) is a service tool for Philips E-box: Consumer Electronics products. ComPair is a further •...
Page 27
Service modes, fault finding and repair tips FTV1.9EE GB 27 • ComPair helps you to quickly get an understanding how to 5.6.2 Searchman (Electronic Service Manual) repair the FTV1.9 in short time by guiding you step by step through the repair procedures.
Page 28
GB 28 FTV1.9EE Service modes, fault finding and repair tips The set has now started up in ComPair mode. Follow the instruction in the FTV1.9 fault finding tree to diagnose the set. Note that the OSD works but that the actual user control is disabled 5.6.4...
Page 29
Block diagrams FTV1.9EE 6. Block diagrams Block diagram 7358 FRONTEND VIDEO PROC. FEATURE VIDEO CONTROL CONTROL/RC5 TDA4665V3 P1 P2 P3 P4 AVB2 AVB1 BOX 4 64µS DELAY +33V 0327 ECO-EURO I/O 7448 TDA8753 FRONTIC DOUBLE WINDOW RGB OUT 1001 7443 TM54C2970 MEMORY...
Page 30
Block diagrams FTV1.9EE I2C bus interconnection diagram (130) (module) DOUBLE WINDOW SMALL SIGNAL PANEL SOURCE SELECT NICAM MODULE IC E9F1 IC 9J IC 9A IC 5N 7822 7823 7814 7581 7352 7580 7500 7600 1300 UV1216D TDA9143 SAB9077H PCF8574 TEA6430...
Page 32
Block diagrams FTV1.9EE Oscillograms B44 +4V3 DC B2 SDA B19 VS-out P2 T1-D TP01 TP10 TP21 11-9143 (WE) B45 +4V3 DC 1V / div DC 1V / div DC 0.1kV / div DC 1V / div DC 1V / div DC 0.5V / div DC...
Alignments FTV1.9EE GB 75 8. Alignments General: the Service Default Mode (SDM) and Service Alignment Mode (SAM) are described in chapter 5 'Service 1 Offset = 4.5uA 1 Offset = 0uA modes, faultfinding and repair tips'. Alignment conditions All electrical adjustments should be performed under the following conditions: •...
Page 76
GB 76 FTV1.9EE Alignments Software Alignments E_BOX WHITE DRIVE TESTPATTERN ADJUST PEAK WHITE LIMITER INPUT LEVEL STEREO DECODER BLUE STEREO CHANNEL SEPERATION GREEN LUMINANCE DELAYS LUM DELAY PAL FBX TEST PATTERN LUM DELAY SECAM CONTRAST LUM DELAY NTSC FV916MG FV916MR...
Page 77
Alignments FTV1.9EE GB 77 The Service Alignment menu has the following items: • Easy link [Yes/No ] • General, see General menu control Changing multiple options by changing option word values (a • Options, see Options menu control word is a 16-bit code).
GB 78 FTV1.9EE Circuit description and list of abbreviations 9. Circuit description and list of abbreviations Circuit description Hardware Software Interface HardWare Input / Output For a detailed description of the circuits see Training Manual IC bus, Inter Integrated circuit, on- FTV1.9 Receiver Box (3122 785 10033).
Page 79
Circuit description and list of abbreviations FTV1.9EE GB 79 TeleteXT TXT-KILL Teletext killer ( Signal to disable Teletext ) U-VIDCONTR U-VideoContrast Voltage Controlled Oscillator Vertical Drive Video Graphics Array. In this document, the term VGA is used for all Write Enable...