Advertisement
B
Load Label Stock (continued)
10. Align the leading edge of the label stock
with the roll as shown.
11. Make sure the labels will be fed under the
Sensor Location Line.
12. Move the Guide Collars so they are close
to, but not pinching the label stock.
13. Lock the labels in place by pushing up on
the metal Liner Idler Roller. Make sure there
are no labels past the Liner Drive Roller.
Lock
Unlock
14. Move the Application Arm to the appropriate height by
squeezing the Pin Release Bar and pulling up on the arm.
Pin Release Bar
Pin
Align Here
Distance from
label stock to
arm side plate
should be
equal in these
locations.
Sensor Location Line
Guide Collars
Liner Idler Roller
Liner Drive Roller
no labels here
Position
Container Height
Notch 4
6" - 8" [15-20 cm]
Notch 3
4" - 6" [10-15 cm]
Notch 2
2" - 4" [5-10 cm]
Notch 1
0" - 2" [0-5 cm]
C
Label/Container Settings (for die-cut labels)
15. Access Label/Container Settings
15a
15b
Recall/
Recall/
-
-
Mode
Reset
+
Mode
Reset
+
Press "Mode" once.
When "F 0" is displayed hold
"Mode" for 2 seconds to access
Label/Container Settings.
16. Sensor Calibration
16a
16b
Recall/
Recall/
-
-
+
+
Mode
Reset
Mode
Reset
Press "Recall/
"SC-" is displayed.
Reset" twice.
17. Platform Position
17a
17b
Recall/
-
Recall/
+
-
Mode
Reset
Mode
Reset
+
Press "Recall/
"PPo" is displayed.
Reset" twice.
18. Guide Position
18a
18b
Recall/
Recall/
-
-
+
+
Mode
Reset
Mode
Reset
Press "Recall/
"gPo" is displayed.
Reset" once.
19. Start Labeling
Push here
Lower the Application Arm quickly until it
touches the container.
The platform will move toward you.
Maintain downward force on the arm until
the label is completely applied.
16c
Push here
Push down on arm until
"0.00" is displayed.
17c
17d
Recall/
Mode
Reset
+
Load the container.
Press and hold "+" or "-"
to move the platform to the
desired labeling position.
18c
18d
Loosen the Thumb Screw
under the platform to
adjust the guide
Recall/
Mode
Reset
side-to-side.
Container
Guide
Press "Mode" to
store settings.
Thumb Screw
under platform
-
-
+
Advertisement
