Electronic Arm Uplift Height Setting - Pilous ARG 260 S.A.F. Instruction Manual

12.4. Electronic arm uplift height setting

On a standard machine, the arm uplift height is adjusted manually on a scale located on the machine's joint. This version is fitted with
a sensor on the machine's joint.
Switch the machine into manual mode (see section 4.1.). Set the END STROKE SWITCH OF THE ARM UPLIFT into position 1, arm
will travel upwards to the maximal position. Shut off the CONTROL VALVE and set the END STROKE SWITCH OF THE ARM
UPLIFT into position 0. Press the DESCENT START and the arm goes down by gradually releasing the CONTROL VALVE. Move the
sawblade to the desired height of the arm by closing the CONTROL VALVE. Press the SAW BLADE STOP and switch MODE into
position AUT. The set arm uplift height is stored in the machine memory after switching the machine to semi-automatic mode. Set the
END STROKE SWITCH OF THE ARM UPLIFT into position 1. After the workpiece is cut, the arm is automatically raised to the set
arm uplift height.
MODE CONTROL VALVE
SAW BLADE STOP
END STROKE SWITCH DESCENT START
/ LAMP
OF THE ARM UPLIFT