Vertical Vice For Hvp Bundle Cutting - Pilous ARG 260 S.A.F. Instruction Manual

Table of Contents

Advertisement

12.3. Vertical Vice for HVP Bundle Cutting

The HVP vertical vice facilitates are used for cutting of materials in bundles.Proper and sufficient clamping of all workpieces in the
bundle significantly influences the service life of the saw blade. The contact pressure plate facilitates vertical clamping of the
workpiece. If a larger bearing surface is required, mount your own fixture of corresponding dimensions onto the contact pressure
plate. Make sure that the guide rods are locked by fixation screws before you start cutting. Check whether the workpiece is
properly clamped, otherwise you risk its ejection during cutting!
WARNING! When using the vertical vice while cutting the workpieces in HVP bundles, you can cut only at 90°.
GUIDE RODS
The HVP packet for one-directional swing saw ARG 260, 300 S.A.F. includes a new movable clamping jaw and also a small clamping
jaw that has to be connected onto a pre-drilled cast iron fixed clamping jaw in front of the cutting line.
The HVP packet for one-directional swing saw ARG 260, 300 plus S.A.F. includes a new movable clamping jaw and also a small
clamping jaw that has to be connected onto a pre-drilled cast iron fixed clamping jaw in front of the cutting line. Longitudinal rods are
usually supplied in three pieces, in order to allow for cutting of a whole range of sections. It is necessary to replace the rod before
cutting in order to prevent collision with the guide head or clamping jaw.
Maximum material HVP
Machine type
ARG 260 S.A.F.
ARG 260 plus S.A.F.
ARG 300 S.A.F.
ARG 300 plus S.A.F.
width
height
290
150
290
150
345
175
345
175
CONTACT PRESSURE PLATE
FIXTURE
FIXATION SCREWS
CONTACT PRESSURE PLATE
50
ø 69

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arg 300 plus s.a.f.Arg 300 s.a.f.Arg 260 plus s.a.f.

Table of Contents