Pilous ARG 260 S.A.F. Instruction Manual page 19

not "cut" the saw blade, but at the same time you have to prevent too much space for the saw blade between the bearings. When the
saw blade moves, the bearings are carried along by the saw blade. Check the tightness of all bolted joints. Unscrew the guide heads
from the bars. Fit the saw blade on the wheels, check its correct alignment on the wheels and tension the saw blade. Install both
guide heads on the saw blade in the space between the bars and adjust them in the correct position on the bars.You can achieve the
correct guide head height in relation to the saw blade by lifting the guide heads, so that the upper hardened steel guide in the guide
head is about 0.5-1 mm away from the upper edge of the saw blade. See the picture. In this way, the correct guide head height
towards the guide bars is achieved.
Set the guide heads perpendicular to the bars and tighten them. If you fail to achieve perpendicularity, the saw blade will either keep
sliding off or running into the wheels. Put back the protective covers of the saw blade, turn on the MAIN SWITCH, press the SAFETY
BUTTON and the hydraulic unit. Carry out a saw blade trial run. Switch off the MAIN SWITCH and secure it against restart, remove
the protective covers of the saw blade and once again check the placement of the saw blade on the wheels. Make a correction, if
necessary - see section 4.6. Put back the protective covers of the saw blade, turn on the MAIN SWITCH, press the SAFETY
BUTTON and the hydraulic unit. Carry out the cutting. You can watch the video with instructions on www.pilous.cz.
GUIDE HEAD SCREW
HARDENED STEEL
MOVABLE
BLADE GUIDE SCREW
GUIDE BAR
ECCENTRIC BEARING SCREW
ECCENTRICALLY
ARRANGED BEARINGS
HARDENED STEEL
BLADE GUIDE SCREW
UPPER HARDENED
STEEL BLADE GUIDES
Correct saw blade guidance
to center between guide bearings
MOVING GUIDE HEAD
FIXED HARDENED
STEEL BLADE GUIDES
MOVABLE HARDENED
STEEL BLADE GUIDES
HARDENED STEEL
BLADE GUIDES WIDTH
ADJUSTING SCREW
FIXED GUIDE HEAD
Incorrect saw blade guidance
COOLANT VALVE
FIXED
GUIDE BAR
SAW BLADE