Safety Instructions; Operator Precautions; Environmental Considerations; Declaration Of Safety Conformity - ABB PowerValue 11 T Series User Manual

1 SAFETY INSTRUCTIONS

1.1

Operator precautions

The user must follow the precautions and only perform the described operations. Also in these measures
the operator of the UPS System must adhere to the instructions in this manual. Any deviation from the
instructions could be dangerous to the user or cause accidental load loss.
WARNING!
WARNING!
WARNING!
1.2

Environmental Considerations

To operate the UPS at the best efficiency point, your installation site should meet the environmental
parameters outlined in this manual. Excessive amount of dust in the operating environment may cause
damage or lead to malfunction. The UPS should be always protected from the outside weather and
sunshine and the operating environment must meet the weight, airflow, size and clearance requirements
specified in the technical datasheet. Under no circumstances, the UPS should be installed in an airtight
room, in the presence of flammable gases, or in an environment exceeding environmental requirements
here below.
An ambient temperature of +20°C to +25°C is recommended to achieve a long life of the UPS and
batteries. The cooling air entering the UPS must not exceed +45 °C and the humidity should be below
90% (non-condensing).
1.3

Declaration of Safety conformity

PowerValue 11 is designed, manufactured and commercialized in accordance with the standard EN ISO
9001 of Quality Management Systems. The marking shows the conformity to the EEC Directive by
means of the application of the following standards in accordance with the specifications of the
harmonized standards:
• 2006/95/EC Low voltage directive.
Standards as reference:
• EN-IEC 62040-1. Uninterruptible power supply (UPS). Part 1-1: General and safety requirements for
UPS's used in accessible areas by end users.
• EN-IEC 60950-1. IT equipment. Safety. Part 1: General requirements.
•
2011/65/EU Restriction of the use of certain hazardous substances (RoHS) DIRECTIVE
The supplier's responsibility is excluded in the event of any modification or intervention in the product by
the customer's side.
RoHS
THE SUPPLIER DOES NOT TAKE ANY RESPONSIBILITY FOR
DAMAGES CAUSED THROUGH WRONG MANIPULATIONS OF THE UPS
SYSTEM.
IT IS PROHIBITED TO REMOVE ANY SCREWS FROM THE UPS
SYSTEM AS THERE IS DANGER OF ELECTRICAL SHOCK.
BEFORE CONNECTING THE MAINS YOU MUST ENSURE THAT THERE
IS A PROPER EARTH CONNECTION!
Product Standards
IEC/EN50581:2012
04-3598_ABB_PVA11_T_1-3kVA_EN_REV-B.doc
Modifications reserved
Standards
IEC/EN50581:2012
Page 6/29 ABB