Operating Control Instruction
Master/Slave
Master
T he master should set as built-in program and shows" P - X – X" send out
:
synchronization signals. To avoid the host signal and DMX512 signals interfere
with each other, should cut off the DMX512 signals. The signal lines are longer
than 60 meters should increase a signal amplifier.
Slave
It must be in the SLAV mode and the address code should be A001 to assure
:
receive the master's signals correctly. Only one light can be set as a Master and
others are slaves.
XLR cable connecting
XRL cable: : : :
The stand connection way of the XRL is: one end connects to the male plug,
and the other connects to the female.
:
Noted
In order to avoid failures and interference signal transmission
a resistance120Ω
(
)
1/4W
at the end of the DMX connecting as below:
,
we connect