I n d e x Summarize ................. 3 Safety instruction ..............3 Outside size picture............. 4 Main function ..............5 DMX controller function ............5 Display operation instruction..........7 Manual instruction............... 8 Operating control instruction..........9 XRL connection instruction ..........11 Connection picture .............13 Problem analyze..............14 Technical’s specification………….…………………………..………16...
Products introduce LED K575POD818RGBW light uses aluminum shell, designed in a fashion of hydrodynamic form. Appearance shows: long can, short can or short can with color filter. It adopts high power 4-in-1 LED, which refers to single LED is made of R,G,B,W LED, And long life span, low consumption, good color mixing effect and high brightness are the most prominent features.
Safety instruction ● Make sure the power supply voltages are consistent with this lights E nsure the , use of voltage is in the range of the request technical parameter. ●before the installation, please check the light’s fasteners and mechanical structure have been received in good condition and appear no damage.
Main Function • Each color of LED with 256 dimming. RGB can make over 16.7 million colors • dim 0%-100%, Strobe g radual change j umping change 、 、 • DMX512 Controller 4 button set DMX ID address with led display ,...
Page 6
CH 4 Channel DMX Value Control Function Remark CH 1 0-255 R 0-100% CH 2 0-255 G 0-100% CH 3 0-255 B 0-100% CH 4 0-255 W 0-100% CH 5 Channel DMX Value Control Function Remark CH 1 0-255 General dimming CH 2 0-255 R 0-100%...
Display Operation • MENU : access the menu or return to a previous menu option • ENTER: select the current menu option • UP: menu selection or parameter increments • DOWN: menu selection or parameters decrease Page 7 of 17...
SouA So.uA Sound Activated on/Off Display on/off nodE nod0-nod4 DMX dimmer mode The edit No of the UErn UE2.0 software Operating instruction MENU ( U P/DOWN ) + ENTER+UP/DOWN ) + ENTER • Remark: Exp: Select the DMX mode, Here are the operation details: •...
Page 10
• Press UP/DOWN , d isplay “LED” • Press ENTER to change the content, the display will glinting at this moment • Press UP/DOWN to select “OFF” • Press ENTER to confirm, the select the working mode that you need. When stop •...
Operating Control Instruction Master/Slave Master T he master should set as built-in program and shows” P - X – X” send out : synchronization signals. To avoid the host signal and DMX512 signals interfere with each other, should cut off the DMX512 signals. The signal lines are longer than 60 meters should increase a signal amplifier.
Page 12
The Conversion between 3pin and 5 pin XLR If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN cable Page 12 of 17...
Problem Analyze Problem Checking way Check the power source plug is in normal or not Can not turn on the Check the switch of the lights is off or on light Check it the fuse if in normal Check the DMX cable is connect to the lights or not DMX can not control Check the DMX512 controller work in normal or not Check the DMX cable is normal or not...
Page 15
Some of the LED not Use the multimeter to check if the led is bright or not, of light not, please change the led check whether current limiting resistor is normal or not Check constant current IC is normal or not (compared with the normal IC) Single color leds Check the switch of this color is normal or not...