Table of Contents
Advertisement
ones-digit as 0-9
press "A" fourthly, switch to built-in program mode, the display's first
word on the left show "P" ,the second for the built-in programs and flashing,
press "B" to modify the built-in program 0-9, "A" for the standby.
press "A" fifthly,the third digit glinting, press B to modify the built-in
programs.
press "A" sixthly, switch to DMX node again,return to step 1.
3. Built-in Program details
The built-in program set as a master send out synchronization signals and
make the slave synchronous with it. The Slave must be set in DMX mode and
the address code should be A001, only set this can take over the signal of
master. The Master outputs controlling signal, and Only one light can be set as
a Master and others are slaves.
"P11-P19": Red dimmer. Operate as: press "A" until the last digit glinting
then press "B" key to change red dimmer (0-9, 9 is the brightest)
"P21-P29": Blue dimmer. Operate as above. (0-9, 9 is the brightest)
"P31-P39": Green dimmer. Operate as above. (0-9, 9 is the brightest)
"P41-P49": Indigo dimmer. Operate as above. (0-9, 9 is the brightest)
"P51-P59": Purple dimmer. Operate as above. (0-9, 9 is the brightest)
"P61-P69": White dimmer. Operate as above. (0-9, 9 is the brightest)
"P71-P79": White Strobe. (P71 is the fastest)
"P81-P89": Auto run built-in program. (P81 is the fastest)
"P91-P99": Gradual change. (P91 is the fastest)
"PA1-PA9": is invalid.
4. When the screen flashes, it indicates that in the set-state..If you do not press any key for 8
seconds, the state will saved automatically, and when you turn on the lights next
time will show this state.
P r- -
（
）
Advertisement
Table of Contents
