Dolphin DOLGDO433D Instructions

Dolphin wireless garage door keypad, 433 mhz dip switch

Dolphin Wireless Garage Door Keypad

433 MHz Dip Switch

Keypad Instructions

Thank you for your purchase of the Transmitter Solutions Dolphin

wireless keypad. The DOLGDO3433D will accommodate one 4 digit PIN

to activate a signal transmission.

Please follow the detailed instructions below in order to set up the Dolphin keypad to

operate with your garage door opener or receiver.

OPERATIONAL FEATURES

Pressing any key illuminates the keypad for 5 seconds.

A "buzzer" indicates each button depression.

After 20 incorrect key entries, the keypad will "lock up" for 40 seconds.

If the battery is low the single LED flashes rapidly for 5 seconds, indicating it is

time to replace the battery.

After you have entered a valid code, the keypad LED will flash during the 5 second

"time out" period. During the "time out" period you may press any key and the

keypad will send another signal to your receiver each time you press a key.

The

key resets your entry. If you make a mistake while entering your PIN,

pressing the

key resets your entry so you can start over.

HINT: If you always begin your PIN with the

faulty operation.

Package contains:

Keypad

9 volt battery

2 screws + wall anchors

Keypad instructions

Product # DOLGDO433D

you will reduce the likelihood of

Table of Contents

Do you have a question about the DOLGDO433D and is the answer not in the manual?

Page 1 9 volt battery 2 screws + wall anchors Keypad instructions Please follow the detailed instructions below in order to set up the Dolphin keypad to operate with your garage door opener or receiver. OPERATIONAL FEATURES Pressing any key illuminates the keypad for 5 seconds.
Page 2 SET DIP SWITCHES a. Set the DIP switches of the keypad to match the DIP switch settings of the receiver, or a functioning transmitter. (see Figure 4) b. Enter then the 4 digit PIN on the keypad, and then press # to activate the receiver.
Page 3 Position the keypad on the garage door frame with the provided screws. Lift up the cover and insert the long screw above the keypad in the slot provided (a). Remove the battery cover and insert the second long screw in the lower slot (b).
Page 4 The warranty period of this product is 24 months, beginning from the manufacturing date. During this period, if the product does not operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter Solutions. This warranty does not extend to the product casing which can be damaged by conditions outside of the control of Transmitter Solutions.