BWT DWFKIT Installation And Operating Instructions

Drinking Water Filter Kit
Installation and Operating Instructions
Model: DWFKIT
Specifi cations:
Pressure Range: 30 – 72 psi (2.1 – 5.0 bar)
Temperature Range: 40 – 77°F (5 – 25°C)
Rated Service Flow: 2.0 Lpm
Filter Capacity: 2000 Litres or 6 months (Max)
Parts Included:
• DWFCART fi lter cartridge C/W integral
push-fi ts connections
• Mounting bracket C/W Screws
• Self cutting tap with tube attached
• Drinking water tap
• 6.35 mm (1/4") plastic tubing

Tools required:

• Phillips Screwdriver
• Towel
• Drill
• Tape Measure
Optional Materials:
• 6.3 & 12.7 mm (1/4" & 1/2") Drill Bit
• Cone-shaped grinding wheel
Precautions:
Do not use with water that is microbiologically unsafe or
WARNING:
of unknown quality without adequate disinfection before
or after the system. Systems certifi ed for cyst reduction
may be used on disinfected waters that may contain
fi lterable cysts.
CAUTION: This fi lter must be protected from freezing, which can cause
cracking of the fi lter and water leakage.
CAUTION: Because of the product's limited service life and to prevent
costly repairs or possible water damage, we strongly
recommend that the head of the fi lter be replaced every
ten years. If the head of your fi lter has been in use for
longer than this period, it should be replaced immediately
Date the top of any new head to indicate the next
recommended replacement date.
CAUTION: Turn off water supply to head without cartridge if it must be left
unattended for an extended period of time.
• File or Sandpaper
• Pencil
• 3.2 mm (1/8") Drill Bit
Customer Help Line: 01376334200
Monday to Friday 08.30 - 17.00
• For cold water use only.
• Make certain that installation complies with all local
bylaws and regulations.
• The contaminants or other substances removed or
reduced by the selected cartridge are not
necessarily in your water. Ask your local water
supplier for a copy of their water analysis.
• After prolonged periods of non-use (such as during
a holiday) it is recommended that the system be
fl ushed thoroughly. Let water run for 2-3 minutes
before using.
• The fi lter cartridge used with this system has a
limited service life. Changes in taste, odour colour;
and/or fl ow of the water being fi ltered indicate that
the cartridge should be replaced.
Installations:
• For standard installation on 15 mm copper, steel, brass or PVC
cold water pipe.
• Please read all instructions and precautions before installing and
using your under-sink drinking water system.
• Numbered diagrams correspond with numbered steps.
1