Step 1, To Mount The Controller - Swegon CONDUCTOR W1 Technical Manual

Step 1, To mount the controller.

Mounting on a DIN rail
If a DIN rail is mounted on the comfort module or at another suitable
location, the controller should be fastened to this rail.
Figur 1.
Pos 1. Plastic hooks
Pos 2. Supporting surface, for example a comfort module or climate beam.
Pos 3. DIN rail
Pos 4. Snap-on fastener.
1.
2.
To mount the controller.
Fasten the two plastic hooks on the backside of the controller on the
upper control edge on the DIN rail.
Press to fasten the snap-on fasteners on the backside of the controller
against the lower control edge on the DIN rail.
Installation
1
2
3
4
3 : 21