Table of Contents
Advertisement
Installation
Technical data
Gas intake connection
·
· Electricity supply
Burner Type
Auxiliary
Semi Rapid
Rapid
Wok 4B models
Wok Dual
5B Models
Instructions for installation
This appliance shall be installed only by authorised persons and in
accordance with the manufacturer's installation instructions, local
gas fitting regulations, municipal building codes, electrical wiring
regulations, AS/NZS 5601 - Gas Installations and any other
statutory regulations.
Data Label - The Data Label is located on the bottom of the
appliance. A duplicate Data Label is supplied to adhere in an
accessible area next to the appliance or on this user manual. This
appliance is suitable for Natural Gas and ULPG; ensure that the
available gas supply matches the Data Label and gas type label.
Ventilation - Ventilation must be in accordance with AS/NZS5601-
Gas Installations. In general, the appliance should have adequate
ventilation for complete combustion of gas, proper flueing and to
maintain temperature of immediate surroundings within safe limits.
Before any procedure, it is important to check that the appliance is
DISCONNECTED from the electrical mains. The Manufacturer
declines all responsibility for any damage deriving from
installations in breach of the regulations in force or from failure to
comply with these installation instructions.
For 90cm models - When installed above a cupboard or drawer, a
protective shelf/shield must be installed at a minimum of 10mm
below the cooktop to insure the base of the cooktop cannot be
accidentally touched when hot. The shield does not need to be a
non-combustible material. Material such as timber or melamine
can be used. The shield needs to be easily removable for
servicing of the appliance. A small gap (10-20mm) should be left
at the front and rear to allow sufficient ventilation to the cooktop.
1/2" BSP
220-240V AC (50Hz)
Natural Gas: 1.0 kPa
Nominal
Injector
Gas Rate
(mm)
3.9 MJ/h
0.90
1.18
6.6 MJ/h
10.8 MJ/h
1.55
1.80
14.0 MJ/h
17.0 MJ/h (total)
1.80 (outer)
2.6 MJ/h (inner)
0.80 (inner)
ULPG: 2.75 kPa
Injector
Nominal
(mm)
Gas Rate
0.53
3.3 MJ/h
0.70
6.1 MJ/h
0.90
10.0 MJ/h
1.05
12.2 MJ/h
0.90 (outer)
12.2 MJ/h (total)
0.46 (inner)
2.2 MJ/h (inner)
15
Hide quick links:
Advertisement
Table of Contents
