For Your Safety These instructions have been drawn up for your safety and that of others. You are therefore requested to read them carefully before installing and using the appliance. Keep this instruction manual for future reference as necessary. If the appliance is sold or moved, make sure that the manual is handed over to the new user.
For Your Safety During use This product is designed to cook foods inside private · homes and for non-commercial purposes. It should not be used for any other purpose. · After using the appliance, make sure that all controls are in 'CLOSED' or 'OFF' position.
For Your Safety Safety of children and the infirm This appliance must only be used by adults. Make sure that children do not touch the controls or play with the appliance. The exposed parts of this appliance heat up during cooking and remain hot for some time even after it is switched off.
Use and Care To light the burners To light the burner, press the control knob fully down and hold the knob down before rotating anti-clockwise to the High Flame position. The ignition device is integrated into the control knob and is automatically activated by pushing down on the control knob.
Use and Care For correct use of the hob For lower gas consumption and better efficiency, use only flat- bottomed pans of dimensions suitable for the burners, as shown in the table below. Also, as soon as a liquid comes to the boil take care to turn the flame down to a level that will just keep it boiling.
Use and Care Cleaning and maintenance Before cleaning, disconnect the appliance from the electrical mains, make sure all burners are 'off' and allow the hotplate to cool down. General cleaning Wash enameled parts with lukewarm water and detergent: do not use abrasive products which might damage them.
Page 10
Use and Care Cleaning and maintenance Ignition plug Automatic burner ignition is provided by a ceramic 'plug' and a metal electrode (E on page 6). Periodically clean these parts of the hob thoroughly. In addition, to avoid ignition difficulties, check that the cavities in the burner are not obstructed.
Use and Care Routine maintenance Have the condition and efficiency of the gas pipe and the pressure regulator (if installed) checked periodically. If anomalies are found, do not repair components but have the faulty component replaced. To ensure good performance and safety, the gas regulator taps must be greased periodically.
Installation Building into kitchen benches These hobs are designed for installation in kitchen benches. When installed into a corner, the walls or panels above the benchtop must be at least 155mm away from the edge of the hob to ensure adequate air circulation to the burners.
Installation Connection to the gas supply There are two ways to make the connection to the main gas line: A. The hotplate can be connected with rigid pipe as specified in AS/NZS 5601. B. The hotplate can be connected with a Flexible Hose, which complies with AS/NZS 1869 (Australian Approved), 10mm ID, class B or D, no more than 1.2m long and in accordance with AS/NZS 5601.
Installation Electrical connection This appliance is designed to operate on a power supply voltage of 220-240V, single phase and is fitted with a 10A, 3 pin plug. Before making the connection, make sure that: 1) The electrical system is able to withstand the load of the appliance (see data label).
Installation Before leaving When the installation is complete, always check for gas leaks using a soapy solution. Never use a flame to make this check. Ignite all burners on high flame to ensure correct operation of gas valves, burners and ignition. Turn gas taps to low flame position and observe each burner to ensure they ignite completely at all ports and that the flame is stable.
Page 21
PROPANE If the required gas conversion kit is not supplied with your appliance, contact Glen Dimplex. Gas Conversion shall only be undertaken by authorised persons. THE NG TO PROPANE CONVERSION KIT CONTAINS Propane Propane...
Page 22
PROPANE If the required gas conversion kit is not supplied with your appliance, contact Glen Dimplex. Gas Conversion shall only be undertaken by authorised persons. THE PROPANE TO NG CONVERSION KIT CONTAINS Propane Propane...
Page 23
Toubleshooting Please complete the troubleshooting before calling for service as user error or installation faults WILL NOT be covered under warranty. General troubleshooting For all issues with the burners, please check the following items first: 1. DO NOT cover any part of the cooktop with foil. As well as being very dangerous, this can cause issues with burners not igniting or burning incorrectly.
Troubleshooting Cooktop issues Burner clicks but will not light: Complete the general troubleshooting on page 23 first. When lighting the burner, be sure to turn the knob to the high flame symbol at the 9 o'clock position (see instructions on page 6) Remove the burner cap.
Page 25
Troubleshooting Cooktop issues (continued) Ignitor keeps clicking: It is most likely some moisture has entered the ignition switches under the knobs. This may be from spillage or when cleaning with liquids. Turn off the cooktop at the power point and allow 24-48 hours for it to dry out before switching it back on.
Page 26
Subject to the exclusions below, we warrant that the product will not have any electrical or mechanical breakdowns within: a) In the case of Technika Professional products used for personal, domestic or household purposes, a period of 2 years (AU) / 2 years (NZ) from the date the product is purchased as a brand-new product from a retailer located in Australia / New Zealand.
Page 27
b) The product requires repairs due to damage resulting from accident, misuse, incorrect installation, insect or vermin infestation, improper liquid spillage, cleaning or maintenance, unauthorised modification, use on an incorrect voltage, power surges and dips, voltage supply problems, tampering or unauthorised repairs by any persons, use of defective or incompatible accessories or exposure to abnormally corrosive conditions, events independent of human control which occurred after the goods left the control of Glen Dimplex;...
Page 28
d) If required by us, provide us (or any person nominated by us) with access to the premises at which the product is located at times nominated by us (so that we can inspect the product). 5. Warranty claims If you make a valid claim under this warranty and none of the exclusions set out in section 2 apply, we will, at our election, either repair the product or replace the product with a product of identical specification (or where the product is superseded or no longer in stock, with a product of as close a specification as possible).
Page 30
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE. The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance. The manufacturer is not responsible for any inaccuracies, due to printing or transcription errors, contained in this manual.