To Light The Burners - Technika TGC6GBK Instructions For Use And Installation

Use and Care

To light the burners

To light the burner, press the control knob down completely and
hold down before rotating anti-clockwise to the 'High' Flame
position. The ignition device is integrated into the control knob and
is automatically activated by pushing down on the control knob.
After lighting the flame, keep the knob pressed for about 5
seconds: this time is necessary to heat up the thermocouple (D on
page 7) and activate the safety valve, which would otherwise cut
off the gas flow.
In the instance of a power failure, place a lit match near the burner
and proceed as described above. If the flame does not light after
the first attempt, wait 5 minutes for the gas to dissipate before
attempting to re-light the burner.
Once lit, check that the flame is even and turn the control knob to
adjust the flame as required. If the flame is uneven, check that the
'burner head/skirt' and 'burner cap' are correctly positioned. To
turn off the flame, turn the control knob clockwise to the 'Off'
position ( symbol ). Before removing pots or pans from the
burners, always turn off the flame.
9