Table of Contents
Advertisement
Troubleshooting
Problem
Possible causes
The cooktop cannot
No power.
Be turned on.
The touch controls are
There may be a slight film of water
difficult to operate.
over the controls or you may be using
the tip of your finger when touching
the controls.
The glass is being
Rough-edged cookware.
scratched.
Unsuitable, abrasive scourer
or cleaning products being
used.
Technical Specification
Ceramic Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size D×W×H(mm)
Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to improve our products we may
change specifications and designs without prior notice.
What to do
Make sure the cooktop is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If you've
checked everything and the problem
persists, contact the Technika service
department.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
Use cookware with flat and smooth
bases. See 'Choosing the right
cookware'. Do not slide any cookware
on the hob.
See 'Care and cleaning'.
CF
M
641
-5
4 Zones
220-240V~ 50 Hz or 60Hz
6000W
590×520×50
565×495
16
Installation
Preparation of the work surface
•
Cut out the work surface according to the sizes shown in the drawing.
•
For the purpose of installation and use, a minimum of 50mm space shall be
preserved around the hole.
•
Be sure the thickness of the work surface is at least 30mm. and suitable for
the application.
L(mm)
W(mm)
M
641
-5
590
520
CF
Ensure the hob is well ventilated and the air inlet and outlet are not blocked. Ensure the
hob is in good working order.
Install Rangehoods and Exhaust Fans in accordance to the manufacturer's instructions.
No closer than 600mm above the hob for Rangehoods and 750mm for Exhaust Fans.
H(mm)
D(mm)
A(mm)
B(mm)
50
46
565
495
17
X(mm)
50 min
Advertisement
Table of Contents
