While Using Group Function - Sony WALKMAN MZ-NH1 Operating Instructions Manual

While using group function

Symptom
The group function does
not operate.
A track cannot be
recorded to a new group.
A new group cannot be
created.
While the recorder is connected to the computer
Symptom
The recorder is not
recognized by the
computer.
Even though the recorder
is recognized by the
computer, it does not
operate normally.
The recorder cannot be
used as a storage device.
The playing time of a
transferred track is
different from the time
that appears on your
computer monitor.
Cause/Remedy
• While using a disc without group setting, an attempt was made to
select some group-related menu.
, Use a disc with group setting.
• This is due to the MiniDisc system limitations (in MD mode
only). Group information has been written to the area where the
disc name is stored. The disc name and track names are recorded
in the same area, which can store a maximum of approximately
1,700 characters. If the total number exceeds this amount, a new
group cannot be created even though group mode is on. It is also
impossible to make group settings at this time.
Cause/Remedy
• The dedicated USB cable is not firmly connected.
, Connect the dedicated USB cable firmly to the recorder and
the computer.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of
the computer.
• Network communication has failed.
, Disconnect the dedicated USB cable, wait at least 2 seconds,
and then reconnect it. If the recorder is still not recognized,
disconnect the dedicated USB cable, restart the computer, and
then connect the dedicated USB cable again.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of
the computer.
• You are using the recorder at a place with vibration.
, Use the recorder at a place with no vibration.
• The SonicStage or MD Simple Burner software is active.
, Close the SonicStage or MD Simple Burner software.
• A standard disc is inserted.
, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD
mode can be used as a storage media.
This is due to a calculation discrepancy between the recorder and
the computer.
85