Sony WALKMAN MZ-NH1 Operating Instructions Manual page 89

Message Meaning/Remedy
DATA SAVE • The recorder is writing information to the system file, such as the
DC IN TOO • Voltage of the power supply is too high (The supplied AC power adaptor
HIGH
DISC FULL • Recording may not be done if the remaining recordable time on the disc
D-L READY • MD Simple Burner is now ready to record an audio CD to the disc in the
EJECT DISC OK • The recorder has finished communicating with the computer and it is
End • The recorder reached to the end of the disc while playing or pressing
ERROR • There is an internal malfunction in the system.
ERROR XX • There is an internal malfunction in the system.
FORMAT • A disc with a format that the recorder does not support was inserted.
ERROR DISC • A disc formatted on the computer was inserted.
GROUP FULL • You tried to create a 256th group on a disc used in Hi-MD mode or 100th
HOLD • The recorder is locked.
IN MENU • You pressed a key on the remote control while selecting a menu on the
• You pressed a key on the recorder while selecting a menu on the remote
MEMORY • You tried to record with the recorder placed where it receives continuous
OVER
NAVI • You pressed a key on the recorder while selecting the Main play mode on
(on the recorder)
NO BATTERY • Recharging was attempted with a non-rechargeable battery inserted.
recorded data or editing information.
, Wait until the message disappears from the display.
or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car battery
cord.
is 48 seconds or less.
, Replace the disc.
recorder using Simple mode. (Refer to "Software Operation" section.)
safe to eject the disc from the recorder or disconnect the dedicated USB
cable.
>.
, Restart the operation by doing steps 1 to 3 on page 87.
, Restart the operation by doing steps 1 to 3 on page 87. If the message
appears again, please consult your nearest Sony dealer.
, Insert a standard MD or a disc used in Hi-MD mode.
, When formatting a disc on the computer, make sure to use the
SonicStage software.
group on a standard disc.
, You can create only up to 255 groups (on a disc used in Hi-MD
mode) or 99 groups (on a standard disc) on a disc. Keep the group
number within 255 or 99.
, Slide HOLD against the arrow to unlock the recorder (page 18).
recorder.
control.
vibration.
, Put the recorder on a stable place, and start recording again.
the remote control.
, Insert a rechargeable battery and start the charging process again.
89