Messages - Sony MZ-NH600 Operating Instructions Manual

Messages

If the following messages flash in the display window, check the chart below.
Message
AVLS NO
VOLUME
OPERATION
BLANKDISC
BUSY WAIT A
MOMENT
CANNOT EDIT
CANNOT
OPERATE
CANNOT
RECORD OR
PLAY
CANNOT SET
DATA SAVE
DC IN TOO
HIGH
74
Meaning/Remedy
• AVLS is set to "AVLS On" and so the volume cannot rise higher.
, Set AVLS to "AVLS Off" (page 52).
• A disc with no recording on it is inserted.
• The recorder is accessing disc information.
• You tried to operate the recorder while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
• You selected, "
recording.
• You tried to erase the track mark at the beginning of the first track or
group.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot
edit.
, Editing titles cannot be done if the title includes characters that
cannot be input on the recorder.
• You tried to press X or T MARK during synchro-recording.
• There is no audio data that can be played on the recorder.
• The audio data or disc management file has been damaged.
, Erase the whole disc (page 48) or perform the Format function
(page 50).
• You tried to make the Time Mark setting during synchro-recording.
• You selected "RECVolume" while the recorder is not in recording-pause.
, Set "RECVolume" while the recorder is in recording-pause.
• You tried to make the following settings while recording.
— Disc Memory
— Play mode
— Recording mode
— Recording level
— Selection of "
• The recorder is writing information to the system file, such as the
recorded data or editing information.
, Wait until the message disappears from the display.
• Voltage of the power supply is too high (The recommanded optional AC
power adaptor or car battery cord is not being used).
, Use the recommanded (optional) AC power adaptor or car battery
cord.
: Set", " : Release", "Move", or "Erase" while
:REC" in menu