Location And Function Of Parts - Sony REA-C1000 Operating Instructions Manual

Location and Function
of Parts
1 2 3
8
9
A
12 V (DC power input) connector
Connect to an AC adapter (not supplied).
Note
For details about supported AC adapters (not
supplied), contact your distributor. Use of other AC
adapters may cause a fire or malfunction.
B
LAN (network) connector (RJ-45)
Connect to a 10BASE-T, 100BASE-TX, or
1000BASE-T switching hub using a LAN cable (not
supplied, category 5 or higher, shielded twisted
pair).
Note
For safety, do not connect the connector for
peripheral device wiring that might have excessive
voltage to this port. Follow the instructions for this
port.
C EXTERNAL connector
Note
Not supported in the current software version.
D HDMI OUT 1/HDMI OUT 2 connectors
Connect to the HDMI input connectors of a display,
projector, or other video device to display the output
video from the unit.
4 5 6
7
9
0
E STATUS button/LED
• STATUS button
Press and hold the button for 5 seconds with the
unit turned so that the POWER LED starts
flashing green. Press and hold the POWER button
for 3 seconds while the LED is flashing to restart
the unit and restore all settings, including
network settings, to their factory default settings.
• STATUS LED
Lights in green when the unit is operating
normally.
Lights in red when not connected to the network.
Flashes in red when an error (such as an over-
temperature alarm) occurs in the unit.
F POWER button/LED
Power is supplied and the POWER LED lights in
green when the unit is connected to an outlet using
an AC adapter (not supplied) and power cord.
To turn the unit off, press and hold the button for 3
seconds. The POWER LED goes out when the unit
turns off.
To turn the unit on again, press the POWER button.
The POWER LED lights in green.
G HDMI IN 1/HDMI IN 2 connectors
Connect to the HDMI output connectors of a
camera, computer, or other video device.
Note
Audio from connected devices is not supported in
the current software version.
H MIC IN connector
Connect to the audio output connector of an audio
device.
Note
Not supported in the current software version.
I Mounting screw holes (four locations on
bottom panel)
Use to mount the unit.
For details, see "Mounting using mounting screws"
(page 7).
J Ratings label (bottom panel)
Important
This label shows the name of the unit and its
electrical ratings.
5