Running The Handwriting Extraction Application - Sony REA-C1000 Operating Instructions Manual

When [Show Person] is cleared: Output the
handwriting extraction only.
Person's transparency
When the overlap mode is set to [Show Person], set
the transparency of the person to be superimposed
by sliding the bar left/right.
4
When finished, click the [Next] button.
5
Set the output image.
If you want to capture not just the extraction range
but also the person, the output range must be
widened keeping the extraction range in the center.
The output range is displayed by a blue frame on the
preview screen. Move the bar left/right to change
the output range with the extraction range in the
center.
This setting is enabled when the overlap mode is set
to [Show Person].
6
When finished, click the [Done] button.
The setup is saved in the unit.
Running the Handwriting
Extraction application
Run this application to extract text and drawings from a
specified drawing board area from the input video and
then output the extracted video.
1
Select [Handwriting Extraction] from
[Applications].
2
Click the [Run] button.
The run screen appears.
You can check the video that is output using the
preview image while the application is running.
You can check the operating status of the
application in the bottom right of the screen while
the application is running.
[Handwriting Detected]: The contents on the
drawing board are being extracted.
[Trying to Detect Handwriting]: Extraction
cannot be achieved successfully at the current
time. Reset the extraction result up to the current
time, and start extracting again.
Notes
• Extraction may not start immediately after starting the
application due to extraction preprocessing.
• When running, you can change the overlap mode and
person's transparency. However, the changes are not
saved in the settings.
• During extraction, the extraction may not be
successful if there are changes in the environment,
such as changes in the brightness of the room.
• The extraction may not be successful depending on
the resolution of the input image.
23