Makita JR100D Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Slider (cont.)
ASSEMBLING
(3) Assemble Gear housing cover to Gear housing (Fig. 8).
Fig. 8
6. Set the following parts to the nearest point to the
DC Motor side as illustrated below.
* Collared sleeve 4 on Gear complete
* Loop portion of Slider
DC Motor
side
(4) Assemble Blade holder section or Blade clamp to Slider (Fig. 9).
Fig. 9
For JR100D
8. Assemble Blade holder section to
Slider.
For JR102D
8a. Set Blade clamp to Slider while aligning
its Screw hole to Concave on Slider. So,
its small hole for Pin 3 is aligned to
the same on Slider automatically.
Screw hole
Blade clamp
Hole for Pin 3
Concave
Slider
Gear complete
Gear housing
Collared sleeve 4
Loop portion of Slider
Gear housing cover
M3x12 Hex socket
head bolt
Slider
9a. Pass Pin 3 through
Blade clamp and Slider.
Pin 3
7. Assemble Gear housing cover to Gear
housing while aligning Collared sleeve 4
into Loop portion of Slider and fix them
with 4x14 Pan head screws (3pcs).
Gear housing
cover
Gear housing
Blade holder section.
10a. Assemble Clamper to Blade
clamp.
Do not approach from the
Cut portion side of Blade clamp
when assembling.
Clamper
(correct assemble)
Clamper
(wrong assemble)
P 5/ 12
Cut portion
of Blade clamp