Makita JR100D Technical Information page 12

W
iring diagram (cont.)
Fig. D-3
Assemble DC Motor to Housing (L),
* the Lead wires must be faced to Housing (R) side.
* the Lead wire (black) must be located to the Switch trigger side.
Housing L
side
30 degrees
Switch trigger side
Bend the Terminal with black Lead wire 30 degrees toward the center
so that the Terminal does not touch the rib for setting DC Motor.
Now, Switch can be mounted to Housing (L) as drawn in Fig. D-5.
Fig. D-5
Pass the Lead wires (black, red) between
DC motor and Switch through Line filter
when it is used.
And put the Line filter to this place.
Route Lead wires (white, black) from
connector to this place and store them
in this place.
Wiring to DC Motor
Red point mark
Housing R side
Wiring of Lead wires of DC Motor, Switch, Terminal in Housing (L)
Line filter location
when it is used.
Store Switch lead wire (red) to Terminal
within the Terminal's width designated
with dotted lines.
Bend Terminal of DC motor inside
so as to be stored between Rib C
Housing (L)
and Rib D.
Switch
Switch
trigger
Fig. D-4
Wiring to Terminal
Connect the Lead wires to
Terminal as drawn below.
Terminal
Rib C
DC Motor
Rib D
Lead wire (red)
P 12/ 12