General Mode; Measuring Your Blood Pressure; Discontinuing A Measurement; Bluetooth And Bp Toolbox App - BIOS Diagnostics PROTOCOL 7D MII BD250 Instruction Manual

3.5 General Mode

In General Mode, a user can take blood pressure measurements outside of the Protocol
Software (7D Mode).
1. When the monitor is OFF, press the SET button, 7D will appear on the screen. Press the MEM
buttons to switch between 7D Mode and General Mode ( ). Press SET to confirm.
2. Next, select the user. Press SET to confirm, then press ST button to power off
the monitor.
3. To start your measurement, see section 3.6 Measuring Your Blood Pressure.

3.6 Measuring Your Blood Pressure

After the cuff with monitor has been appropriately positioned, and the correct mode has been selected, the
measurement can begin:
1. Press the ST button until all the symbols appear on the screen. Right after " " will flash on the
screen, see section 3.8 to use the Bluetooth function OR press the ST button again to continue
with the measurement. You will hear 2 short beeps and after " " will flash for 2 seconds. The pump
then begins to inflate the cuff. The increasing pressure in the cuff is shown on
the display.
2. After the suitable pressure has been reached, the pump stops and the cuff gradually deflates.
The cuff pressure will then be displayed. In case the initial inflation is not sufficient, the device
automatically re-inflates to a high pressure.
3. When the device detects a heartbeat, the heart symbol " " on the display starts to flash and you
can hear a beep for every heartbeat.
4. When the measurement has been completed, you will hear a long beep and the systolic, diastolic
and pulse rate will appear on the display.
5. The measurement readings remain on the display until you switch off the device. If no button is
pressed, the device switches itself off in 3 minutes.
NOTE: The symbol "
detected during the measurement. If the "
in a week), it may be an indication of a more serious heart problem, and you should consult
your doctor.

3.7 Discontinuing a Measurement

To stop the measurement (eg. the patient feels unwell) press the ST button. The device will immediately
decrease the cuff pressure automatically.

3.8 Bluetooth and BP Toolbox APP

The APP will work with the following operating systems:
iOS Support: iPhone 5, iPhone 5s, iPhone 6, iPhone 6p, 6s, 6sP, iOS 7.1 and up, Bluetooth 4.0
Android: System 4.3 and up, Bluetooth 4.0
1. To begin using the free BP Toolbox APP, download and install onto your smartphone or tablet.
" will be displayed along with the reading if irregular heartbeat has been
BP Toolbox
" symbol appears frequently (e.g. several times