Using The Ac/Dc Power Adapter; Using The Device; Select The User; Setting Time, Date And Year - BIOS Diagnostics PROTOCOL 7D MII BD250 Instruction Manual

2.4 Using an AC/DC Power Adapter
You may also operate this monitor using an AC/DC adapter
(output 6V/600mA).
1. Ensure that the AC/DC adapter and cable are not damaged.
2. Plug the adapter cable into the AC/DC adapter port on the
bottom of the blood pressure monitor.
3. Plug the adapter into your electrical outlet. When the adapter
is connected, no battery current is consumed.

3. Using the Device

This section describes how to get the maximum benefit from your blood pressure monitor. Follow the
instructions carefully to get an accurate measurement of your blood pressure and pulse rate.
NOTE: Setting the user, year, month, date and time is one sequential process

3.1 Select the User

1. Start with the monitor OFF, but with batteries or adapter inserted.
2. Press the SET button twice, press the MEM button to switch
between User 1 and User 2.
3. Press SET button to confirm.
NOTE: Press the ST button to turn the monitor ON or OFF
3.2 Setting the Time, Date and Year
1. When the monitor is powered OFF, press the SET button 3 times, the YEAR will flash.
Press the MEM button to choose the year and press SET to store in
the memory.
2. Repeat the same process to set the MONTH by pressing the MEM button.
Press the SET button to store it in the memory.
3. The same process is repeated to set the DATE. The date will flash and can be changed
by pressing the MEM button. Afterwards, HOURS will begin to flash.
4. TIME; hours, and then minutes can be set following the same procedure by pressing
the MEM button.
5. Next " " will flash, press the MEM button to switch between the alarm being
OFF or ON. To set the alarm, select "
will begin to flash, press the MEM button to change the HOUR digits. Press the SET
button to confirm.
6. Next the MINUTE digits will flash, follow the steps above to set the digits. Once Alarm 1 is set you can also
set Alarm 2 following the same steps. (See section 3.12)
7. After the minutes have been set, "
section 3.10 to clear the memory.
NOTE: In order to change any setting you must repeat the process and confirm each setting by
pushing the SET button.

3.3 Obtaining Accurate Measurements

Your blood pressure can vary based on numerous factors, physiological conditions, and your surroundings.
Follow these guidelines to obtain accurate and error-free measurements of your blood pressure and pulse rate.
" and press the SET button. The HOURS
" will appear on the display. Press the SET button to disregard. See