Advertisement
Quick Links
Advertisement
Related Manuals for Rabe Combi-Digger Series
Summary of Contents for Rabe Combi-Digger Series
- Page 1 Order-No. 9900.01.44GB01 Operating Instructions Subsoiler Combi-Digger...
- Page 2 The use of non-original accessories, spares and/or consumables that do not carry specific approval from Rabe shall void all warranty liabilities. We can accept no liability whatsoever for damage, loss or injury resulting from the carrying out of unauthori- sed repairs and/or modifications to the device.
-
Page 3: Machine Data
Machine data Combi-Digger Lengths in mm Working Weight (approx.) Basic type Loosening tines depth in kg approx. (approx.) Combi-Digger 3004 Combi-Digger 3006 Combi-Digger 3008 1100 3000/ 200-450 mm 1700 Combi-Digger 4006 4000 Combi-Digger 4008 1050 Combi-Digger 4010 1230 The use of additional equipment may increase the weight. We reserve the right to make technical changes. - Page 4 Safety precautions Do not allow anyone to stand between the tractor and the device during coupling or uncoupling, even if this is to allow operation of the external hydraulic controls. Danger of injury: The operator should run the machine from the trac- tor driver’s seat at all times.
- Page 5 Attachment / Removal Check for matching connection ratings (category II or III). Adjust both lower arms to the same height. Start by hitching the lower arms to the device. Then attach the upper arms. You can now retract the support stands (4.1/1). Correctly secure the coupling assembly (three- point linkage).
-
Page 6: Residual Risks
Shearing-pin safety device The lower one of the two screws (5/1) used to secure the tines to the tine holder is configured as a shearing pin to protect against overloading. If it breaks, a new original screw (M24x1.5x X, strength rating 8.8) must be fitted. The upper screw should also be checked for damage, and replaced if necessary. - Page 7 A lighting system – with warning panels – can also be obtained from RABE as an optional extra. When transporting on public roads in Poland, the warning triangle (7.1/1) must be fixed to the centre of the machine.
- Page 8 Arrangement of warning signs on the device For key to symbols, see following warning signs. We reserve the right to make technical changes.