Etel DSC Series Operation & Software Manual page 109

stored in parameter K53 (phase shift adjustment).
Caution: When parameter K90 or K68 is modified, the command AUT = 10 must be executed to re-
calculate parameter K53.
• K90 = 5: Phasing and commutation with digital Hall effect sensor only
Available on
The commutation is only done with the digital Hall effect sensor.
Caution: When parameter K90 or K68 is modified, the command AUT = 10 must be executed to re-calculate
parameter K53.
Remark: Refer to the corresponding 'Hardware Manual' for more information about the connection of the
Hall effect sensor.
ETEL Doc. - Operation & Software Manual # DSC2P 903 / Ver. F / 3/6/05
Operation & Software Manual
Direct Drives & Systems
MOTOR
Reference mark
ENCODER
Encoder with K53 (LKT)
Encoder
DSC2P DSC2V
MOTOR
Encoder with K53 (LKT)
Hall
DSCDP DSCDL
Hall
109
DSCDM
Chapter C: System functions