Adjustment Of The Feed Mechanism; Zeroing Of The Feed Adjusting Mechanism - JUKI LU-2210N-7 Engineer's Manual

(7) Adjustment of the Feed Mechanism

1) Zeroing of the feed adjusting mechanism

Slot
Standard Adjustment
Section A
Marking (chamfered)
• Align the feed adjusting pin
tion A of the feed adjusting belt
• Make sure that the marking on the feed ad-
justing eccentric pin
direction as the slot in the feed adjustment
change arm
• Tilt the feed change belt
of C or D until the feed amount of the feed
dog becomes zero (0). At that position, fas-
ten the set screw
• Align the marking
plate
with [0] on the scale of the stitch dial
Level H
Level L
– 30 –
with the sec-
faces in the same
.
in the direction
.
of the face aperture
on the front face of the machine
.
.