Power Supply; Remote Control; Sound Adjustment - Aiwa CSD-TD10 Operating Instructions Manual

Power supply

Using on AC house current
Connect the AC cord as illustrated below.
supplied AC cord
CAUTION
Use only the supplied AC cord. Use with other cords
may result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, with
the 0 and 9 marks correctly aligned. Then close the
lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
When to replace the batteries
The tape speed slows down, volume decreases, or
sound is distorted during operation.
Notes on batteries
• Do not mix different types of batteries or old batteries
with new ones.
• When the unit is not to be used for a long period,
remove the batteries to prevent needless battery
wear.
• Never recharge the batteries, apply heat to them or
take them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
4
ENGLISH
to the AC inlet of the unit
to an AC outlet
(AC 120 V, 60 Hz)
R14 (C)

Remote control

Insert two R6 (size AA) batteries.
When the reach of the remote control signal is less than
5 meters (16 feet), replace the batteries.
The remote control may not operate correctly
when:
- The unit is exposed to intense light, such as direct
sunlight
- Objects block the remote control signal to the unit
To use the buttons on the remote control
Buttons on the remote control and the main unit with
identical indications have the same functions.

SOUND ADJUSTMENT

Volume or tone adjustment does not affect
recording.
VOLUME
Turn VOLUME to adjust.
T-BASS system
The T-BASS system enhances the realism of low-
frequency sound.
Set T-BASS to ON or OFF.
(CSD-TD30 only)
R6 (AA)