Programmed Play; Specifications - Aiwa CSD-TD10 Operating Instructions Manual

PROGRAMMED PLAY

Up to 16 tracks can be programmed from the disc.
1
In stop mode, press PROGRAM.
2
Press r, t to select a track, then
press PROGRAM to store it.
Track number
3
Repeat step 2 to program other tracks.
4
Press s to finish the program.
Total number of
the programmed tracks
5
Press e to start play.
To check the program, press r or t in stop
mode.
To clear the program, hold down PROGRAM in stop
mode until the display changes.
To change the programmed tracks, clear the
program and repeat all the steps again.
(CSD-TD30 only)
Program number

Specifications

Radio section
Frequency range, antenna – FM: 87.5 - 108.0 MHz Rod
antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz
step) Ferrite bar antenna
Deck section
Track format – 4 tracks, 2 channels / Frequency range
– Normal tape: 50 - 12,500 Hz (JEITA) / Recording
system – AC bias / Erasing system – Magnet erase /
Heads – Recording/playback head (1), Erasure head
(1)
CD player section
Disc – Compact disc / Scanning method – Non-contact
optical scanner (semiconductor laser) /
Laser diode properties –
Material: GaAlAs
Wavelength: λ = 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW (This output is the
value measured at a distance of 200 mm from the
objective lens surface on the optical pick-up block with
7 mm aperture.)
General
Speaker – 100 mm cone type (2) / Power output –
2 W + 2 W (JEITA 8 ohms, T.H.D. 10% DC) / Power
requirements – DC 12 V using eight size C (R14)
batteries, AC 120 V, 60 Hz / Power consumption – 12
W / Dimensions (W × H × D) – 390 × 170 × 258.5 mm
× 6 × 10
3 3 1
(15 / / / in.) / Weight (excluding batteries)
8 4 4
– 2.7 kg (5 lbs. 15 oz.) / Accessory – Remote control
(1, CSD-TD30 only), AC cord (1)
Specifications and external appearance are subject to
change without notice.
COPYRIGHT
Please check the copyright laws relating to
recordings from disc, radio or external tape for the
country in which the machine is being used.
If an erroneous display or malfunction occurs
Select CD function first. Hold down s and press e.
If the unit cannot be reset in the way above, disconnect
the AC cord and remove all the batteries to turn off the
display.
Leave the unit for a while and turn the power back on.
9
ENGLISH