Power Supply; Specifications; Using On Ac House Current - Aiwa CSD-TD20 Operating Instructions Manual

Power Supply

6 STANDBY
OPE/BATT
The 6 STANDBY OPE/BATT indicator lights up while electric
current flows to the unit.

Using on AC House Current

Connect the AC cord as illustrated below.
supplied AC cord
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Using on Batteries
Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, with the 0
and 9 marks correctly aligned. Then close the lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
When to replace the batteries
The 6 STANDBY OPE/BATT indicator becomes dim, the
tape speed slows down, volume decreases, or sound is
distorted during operation.
Notes on batteries
• Do not mix different types of batteries or old batteries with
new ones.
• When the unit is not to be used for a long period, remove
the batteries to prevent needless battery wear.
• Never recharge the batteries, apply heat to them or take
them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Unless otherwise noted, the illustration in the Operating
Instructions shows the CSD-TD21.
to the AC inlet of the unit
to an AC outlet
(AC 230 V, 50 Hz)
R14 (C)

Specifications

Tuner section
Frequency range, antenna — FM: 87.5 - 108.0 MHz Rod antenna,
MW: 531/530 - 1,602/1,710 kHz (9/10 kHz step) Ferrite bar antenna,
LW: 153 - 288 kHz Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels / Frequency range — Normal tape:
50 - 12,500 Hz (EIAJ) / Recording system — AC bias / Erasing system —
Magnet erase / Heads — Recording/playback head (1), Erasure head (1)
CD player section
Disc — Compact disc / Scanning method — Non-contact optical scanner
(semiconductor laser)
General
Speaker — 100 mm cone type (2) / Output — Headphones jack (stereo
mini-jack) / Power output — 2.5 W + 2.5 W (EIAJ 7 ohms, T.H.D. 10%),
1.9 W + 1.9 W (DIN 1% Rated Power) / Power requirements — DC 12 V
using eight size C (R14) batteries, AC 230 V, 50 Hz / Power
consumption — 16 W
Dimensions (W H D) — 435
Weight (excluding batteries) — 3.7 kg
Accessory — AC cord (1)
• Specifications and external appearance are subject to change without
notice.
• Specifications, trade mark, model name and the double square symbol
are marked on the bottom of the unit.
COPYRIGHT
Please check the copyright laws relating to recordings from disc,
radio or external tape for the country in which the machine is being
used.
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol,
benzine or thinner.
To clean the heads
When the tape heads are dirty;
- high frequency sound is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a
head cleaning cassette.
Use separately sold dry-type or wet-type cleaning
cassette.
Refer to the instructions of the cleaning cassette for
details.
To clean the lens
Use a cotton swab slightly
moistened with cleaning fluid.
Wipe gently from the center to
the edge.
184 277 mm
Lens
ENGLISH
3