Advertisement
2. Muminam Wting
A. Connectlength of copper buildingwire to
range terminal block.
B. Splicecopper wties to aluminumwiring using
specialconnectors designed and U.L.approved
for joining copper to akuninum,and followthe
connector manufacturer'srecommended
procedure closely.
NOTE:Wire used, locationand enclosure of
splices, etc., must conformto good wiring
practice and local codes.
wmNG:
Frame grounded to neutral of apphance
through a fink. If used in a MOBILEHOME or
if LOCN CODES do not permit grounding
through the neutral:
1) disconnect the link horn neutial,
Z) use grounding terminal or lead to ~ound
unit in accordance with local codes, and
3)
connect neutral terminal or lead to branch
circuit in usual manner.
(If the applianceis to be connected by
means of a cord set, use 4-conductorcord
for this pu
ONNECTOR
LOCK
;
..-
~JM~~~~
1. Wge must be secured by NTI-TIP bracket
suppfied.
2. See instructions to install (suppfiedwith
bracket).
3. Unless properly installed,range couldbe
tipped by stepping or sitting on door. Injury
might result horn spilledhot fiqtiidsor from
range itse~.
Typical
installation of
Anti-Tip
bracket
Attachment
toWa!!
Bracket
\
S?EP 7
LEVELBHC
TMS m%E
The range must be level. Levelingfeet are
located at each corner of the base of the range.
Removethe storage drawer or kick panel
(depending on your model) and using channel
locks, rotate the levelingfeet in and out as
required to levelthe range. For instructions on
how to remove and replace the storage drawer or
the kick panel, see the Cleaning Under the Wnge
section in Care and Cleaning.) On some models,
there are plastic covers which may be removed
for easy adjustment Qustsqueeze and pull).
One of the rear leveling feet will engage the
~TI-T'IP bracket (allowfor some side to side
adjustment). Allowa minimum clearance of 1/81'
between the range and the leveling foot that is to
be installed into the ~TI-TIP bracket.
Check the range for proper installation into the
NTI-TIP bracket (after the range has been
properly installed) by grasping the edges of ti~e
~~
burner holes and carefully attempting to
tilt the range forward.
—. , .= . --.-...-.-——
~—+...-"--------------
,
—
Advertisement
