Advertisement
Presets & Control
Presets
The Adamson LoadLibrary, found on the Adamson website, contains presets designed
for a variety of IS7 applications. Each preset is intended to be phase-linear with either
the IS118 or IS119 subwoofers.
IS7 Lipfill
Intended for use with a
single IS7
Control
Array Shaping overlays (found in the Array Shaping folders of the Adamson Load Library) are available so
comparisons can be made between the "Array" preset and the "Short" preset. When the "Array" preset is loaded, the
"Short" Array Shaping overlay can be recalled in the EQ section of Lake Controller to adjust the contour of the array to
compensate for less enclosures.
Tilt overlays (found in the Array Shaping folders of the Adamson Load Library) can be used to alter the overall acoustic
response of an array. Tilt overlays apply a filter, centered at 1kHz, which reaches the noted decibel cut or boost at the
extreme ends of the listening spectrum. For example, a +1 Tilt will apply +1 decibel at 20kHz and -1 decibel at 20Hz.
Alternately, a -2 Tilt will apply -2 decibels at 20kHz and +2 decibels at 20Hz.
Please refer to the Adamson PLM & Lake Handbook for detailed instructions on recalling Tilt and Array Shaping
overlays.
Adamson Systems Engineering | IS7 User Manual
Adamson Systems Engineering | IS7 User Manual
IS7 Short
Intended for use with an array
of 7 or less IS7
IS7 Array
Intended for use with an
array of 8 or more IS7
Page 7
Page 7
Advertisement
