Presets & Control - Adamson S7 User Manual

S7
Presets
The Adamson Load Library
phase-aligned within the EQ overlap region with either S118 or S119 subwoofers.
For a master list, please refer to the
When cabinets and subwoofers are positioned separately, phase alignment
should be measured with suitable software.
S7 Lip Fill
Intended for use with a
single S7
Control
Array Shaping overlays (found in the Array Shaping folders of the
section of Lake Controller to adjust the contour of the array. Recalling the appropriate EQ overlay or preset for the
number of cabinets being used provides the standard Adamson frequency response of your array, compensating for
different low-frequency coupling.
Tilt overlays (found in the Array Shaping folders of the
response of an array. Tilt overlays apply a filter, centered at 1kHz, which reaches the noted decibel cut or boost at the
extreme ends of the listening spectrum. For example, a +1 Tilt will apply +1 decibel at 20kHz and -1 decibel at 20Hz.
Alternately, a -2 Tilt will apply -2 decibels at 20kHz and +2 decibels at 20Hz.
Please refer to the Adamson PLM & Lake Handbook
overlays.
Adamson Systems Engineering |
contains presets designed for a variety of S7 applications. Each preset is intended to be
Adamson PLM & Lake Handbook.
S7 Short
Intended for use with an array
of 4 to 6 S7
for detailed instructions on recalling Tilt and Array Shaping
S7 User Manual
Adamson Load
Adamson Load Library) can be used to alter the overall acoustic
S7 Array
Intended for use with an
array of 7 to 11 S7
Library) can be recalled in the EQ
Page 7