Table of Contents
Advertisement
B
issell PowerSteamer® ProHeat™ Series Service Center Repair Guide
LOWER HANDLE ISSUES
1.
Handles must be reassembled to ensure that hoses are not pinched.
2.
Clear any blockages in the heater inlet and outlet lines with a finishing nail or similar
object.
3.
To open the heater, remove screws located on its rear panel.
1.
Check heater function by attaching a 120-volt source to heater terminals and waiting 30
seconds -- unit should get hot.
2.
Heaters have an extremely low failure rate -- make absolutely certain a heater is broken
before ordering a new one.
1.
Make certain the "hook" is placed properly into the alignment slot.
Printed February, 2001
1/30/2004 (Revision 1)
HEATER ISSUES
CLEARVIEW ISSUES
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PROHEAT PRO-TECH #1699 and is the answer not in the manual?
Questions and answers