Advertisement
1). In cooling mode, the set temperature will be increased 1deg automatically after one
hour's running, and increased 1deg again after another one hour's running, then unit stops after
working total 6 hours.
2). Under heating mode, the set temperature will be decreased 1deg automatically after one
hour's running, and decreased 1deg again after another one hour's running, then unit stops
after working total 6 hours.
4.3 REMOTE CONTROL HANDSET OPERATION
4.3.1. How to assemble batteries and set the time
●Insert batteries (Figure 18)
1. Slide the back cover open.
2. Place the batteries into the slot, please pay very close attention to the correct polarity!
3. Close the back cover.
Note:
1. The positive pole and negative pole of the battery must correspond with the respective pole
one the remote controller handset.
2. Do not mix new batteries with old ones.
3. Please remove the batteries when the controller is not to be used for a long time or the
batteries are discharged.
4. To avoid environmental pollution, make sure the batteries are removed before discarding.
Dispose of them properly at a designated waste disposal site.
Fig18
- 16 -
Advertisement
