Advertisement
3.3.5
Assemble bottom trim panel
Unscrew 5 foot pads, and assemble the bottom trim panel to bottom of unit (Figure 16)
Note: Please do not assemble the bottom trim panel onto the unit if you want greater fresh air
exchange.
4. OPERATING INSTRUCTIONS
This heat pump is designed based on "T1" working conditions where its running
environmental temperature range is –7 degrees C to 43 degrees C
When the electric supply is first connected and live, the machine will make a short beep
sound, upper and lower air outlet covers will open automatically then close and keep this status.
The unit is now ready for operation. If there is no response when power is connected, check
there actually is a live supply coming through.
This heat pump is best operated using the remote control handset. Please make sure the
batteries are connected and in good condition
Note: There is an emergency switch on the display panel. You can use it to operate the unit
when the remote controller is missing or lost. It will only work in auto mode. Press the button for
at least 3 seconds to switch the unit on or off; the upper and lower air outlet covers will
automatically open when the unit is on
Fig15 – Connecting Atomising Device
Fig16
- 12 -
Advertisement
