Model Name Designation - Yamaha 2CMH Rigging Manual

MODEL NAME DESIGNATION

The model primary ID that consists of the model name, prefix model code, transom length and serial
number is stamped on the label attached to the clamp bracket.
* The serial number is a 7-digit sequential numbering scheme irrespective of model variation and transom
length.
GLOBAL MODEL IDENTIFICATION (EXCEPT US AND CANADA)
Prefix model code
The model identification has been standardized as follows since 1998 model year.
FL
Model category
Non: 2-stroke STD engine
D: Twin rotating prop
E: Enduro series
F: 4-stroke engine
K: Kerosene engine
L: L/H rotation series
T: High thrust (4-stroke)
Z: HPDI engine
Transom height
F L 3 5 0 A E T
U
6 A X
YAMAHA MOTOR CO., LTD.
MADE IN JAPAN
PAYS D'ORIGINE JAPON
350 A
Output Model
(PS) generation
2 A
to B
350 C
D
F
G
H
J
L
N
P
Q
R
S
T
U
V
X
Y
(Repeat
from A)
8-2
Model name
Serial number
ET
Model variation
Level 1: Start system
M: Manual start
E: Electric start
W: Electric & Manual start
Level 2: Control system
Non: Remote control
H: Tiller handle
C: Remote control w/ tiller handle
Level 3: Trim & Tilt system
Non: Manual tilt
D: Hydro tilt
P: Power tilt
T: Power trim & tilt
Level 4: Lubrication system
[2-stroke engine]
Non: Premixed fuel engine
O: Oil injection engine
U
Transom height
(Drive shaft length)
S (15")
L (20")
Y (22.5")
X (25")
U (30")