Speedometer Tube Routing; Digital Speedometer Set Up - Yamaha 2CMH Rigging Manual

SPEEDOMETER

SPEEDOMETER TUBE ROUTING

1. Cut off about 3 mm (0.12 in.) from the end
of the nipple of the speedometer tube to
open it.
2. Route the speedometer tube carefully to
avoid crimping or damage.
3. Connect the tube to the nipple.
* The optional speed sender (P/N: 688-83556-
01) is required if the speedometer tube is not
equipped to the clamp bracket area.
* In high-performance applications where the
engine has been mounted in an elevated
position, it may be necessary to use the
optional speed sender to obtain a correct
reading.

DIGITAL SPEEDOMETER SET UP

1. Remove the rubber grommet from the back
2. Set the toggle dipswitches on the chart as
3. Reinstall the grommet.
Cut off 3 mm
(0.12 in.)
Display
SW.3
SW.4
Fuel
sender
* The switch position in the illustration shows the
initial setting, which is the mph display and ABYC
fuel sender.
5-11
the meter.
below.
SW.1 ON
SW.2 ON
km/h
ON
ON
Yamaha
original
5 – 105 Ω 30 – 240 Ω
OFF OFF
ON OFF
mph knot/h
OFF OFF
ON OFF
ABYC
Europe
(US)
180 – 0 Ω