schmersal RSS260 Operating Instructions Supplementary Sheet

Operating Instructions Supplementary Sheet
Combination of sensor and actuator
Operating instructions. . . . . . . . . . . . .pages 1 to 2
EN
Translation of the original operating instructions
Aktuální verzi návodu k použití
CS
ve vašem jazyce naleznete na
www.schmersal.net.
Encontrará el manual de
ES
instrucciones actual en su
idioma oficial de la UE en
nuestra página de Internet
www.schmersal.net.
Il manuale d'istruzioni aggiornato
IT
nella vostra lingua (lingua ufficiale
UE) è scaricabile in Internet
all'indirizzo
www.schmersal.net.
U vindt de huidige versie van
NL
de gebruikshandleiding in uw
officiële landstaal op het Internet,
www.schmersal.net.
O manual de instruções actual,
PT
no seu idioma oficial da UE,
encontra-se na nossa página de
Internet www.schmersal.net.
På www.schmersal.net findes
DA
aktuelle betjeningsvejledninger
på EU's officielle sprog.
Vous trouverez la version
FR
actuelle du mode d'emploi dans
votre langue nationale officielle
sur l'Internet,
www.schmersal.net.
EU公用語で書かれた最新の
JP
取扱説明書は,インターネッ
(www.schmersal.net) から
ダウンロードできます。
Tutaj znajdziesz aktualną wersję
PL
instrukcji obsługi w Twoim
języku na stronie internetowej
www.schmersal.net.
På www.schmersal.net finner
SV
ni de aktuella versionerna av
bruksanvisningen på EU's
officiella språk.
Destination and use
The RSS260 safety sensor can be optionally used on safety guards in
combination with the RST-U-2 actuators. The operating instructions of
the RSS260 is to be considered.
When using the combination of RSS260 and RST-U-2 deviating or
additional instructions for assembly position and switching distances
are listed below.
Warning about misuse
In case of improper use or manipulation of the safety switch-
gear, personal hazards or damages to machinery or plant
components cannot be excluded when safety switchgear is
used. The relevant requirements of the standard ISO 14119
must be observed.
Mounting
During fitting, the requirements of ISO 14119 must be
observed.
The mounting hole of the RST-U-2 provides a mounting by means M3
countersunk screws (max. tightening torque 0.6 Nm). The active areas of
the safety sensor and the actuator have to face each other.
Safety sensor and actuator must be permanently fitted to
the safety guards and protected against displacement by
suitable measures (tamperproof screws, gluing, drilling
of the screw heads).
A 1.2mm pin into the rear hole of the RST-U-2 prevents twisting, if this
cannot be excluded otherwise by mounting.
Dimensions
All measurements in mm.
Safety sensor RSS260
22
39. 2
47. 5
Actuator RST-U-2
22
15
M3
¤6
¤1. 2
4
16. 5
EN
RSS260 / RST-U-2
18