Disinfecting; Maintenance And Servicing; Firmware Updates - Ectosense NightOwl Healthcare Professional Manual

It is recommended to subject the sensor to cleaning as described above in between use by different
patients. Recommend patients to perform such cleaning at home when the sensor remains with them for
an extended period of time.

6.2 Disinfecting

After cleaning the sensor as instructed above, disinfect the device as follows:
1. Apply undiluted disinfectant to a clean non-dyed disposable cloth.
2. Wipe all surfaces of the sensor.
3. Leave the disinfectant on the sensor for five minutes.
4. Wipe residual disinfectant from the sensor with a clean, dry, undyed disposable cloth.
The following disinfectants can be used on the sensor:
 70% Ethyl alcohol or isopropyl alcohol (IPA)
 Mikrozid
 Cavicide

6.3 Maintenance and servicing

Other than routine cleaning, there is no additional maintenance or calibration required.
There are no user serviceable parts. Do not attempt to open the device or any of its
components
Any device failure should be communicated to Technical Support (see 2 Contacting us) after carefully
reading the 7 Troubleshooting section of this document.

6.3.1 Firmware updates

The embedded software on the sensor ("firmware") can be updated over a BLE connection with a qualified
smartphone app.
NightOwl® Diagnostic System
The firmware can be updated automatically prior to a patient starting a recording if he or she is using
the NightOwl® Companion app, or can be manually updated using the Ectosense Healthcare
Professional app under the assistance of a technical representative.
Instructions for Use – NightOwl ® Sensor – Healthcare Professional Page 18 of 24