Device Set-Up - Ectosense NightOwl Healthcare Professional Manual

5.3 Device set-up

3. Turn on the sensor.
4. Place the sensor with the white side up.
5. Take a new adhesive and remove its top liner
on the round sided end.
6. Adhere the round, sticky side of the adhesive
on top of the white side of the sensor
8. Remove the second part of the liner
9. If the wrap breaks or gets damaged
during the application, just take a
new one.
Instructions for Use – NightOwl ® Sensor – Healthcare Professional
1. Place the finger on the green side of the
sensor. Make sure the finger is aligned with
the sensor and it rests flat on the sensor.
2. Preferably, the sensor is worn on the index
finger of your non-dominant hand to minimize
signal distortion due to motion.
7. Wrap the adhesive snugly around the finger, so
that it does not move around. If ever the
adhesive feels uncomfortably tight, rewrap it
more loosely.
Page 14 of 24