Modes And Configurations - Ectosense NightOwl Healthcare Professional Manual

4. Disposable finger wraps (single-use)
5. Charging cable (USB-A to USB-C) to connect the charging cradle with the power plug;
6. Power plug with USB-A port (optional, depending on your geography).
Do not use the Sensor with accessories that are not expressly indicated by Ectosense as fit for
use as this may cause damage, injuries, loss of performance, and voidance of the warranty.
In particular, pay attention not to use the charging cradle with a power plug that does not
output 5 VDC 700mA nominal, 1A max.

4.1 Modes and configurations

The NightOwl® Sensor can operate in two modes. Selection of modes is automatic and will not require
active operator intervention.
1. Streaming Mode
When the sensor is turned on, it will first seek to establish a Bluetooth® Low Energy (BLE) connection with
a nearby smartphone with a qualified smartphone app installed (see blue box below).
Upon such connection and subsequent start of the recording, the sensor will stream its data to the
smartphone in real-time, without storing this data on the sensor itself.
NightOwl® Diagnostic System
Ectosense makes available the NightOwl Companion app for patients to connect with the Sensor.
Upon completion of a recording, the NightOwl Companion app automatically uploads the transferred
data to the NightOwl Software for further analysis through WiFi or via an available mobile network
connection.
2. Offline Mode [functionality not enabled yet]
If no qualified smartphone application is found after turning on the sensor (see Streaming Mode), the
Sensor will automatically switch to its Offline Mode. In this mode, the Sensor will store up to 30 hours of
recording on its internal memory, after which the operator is required to download the data through an
active Bluetooth® Low Energy (BLE) connection.
A time-stamp is added to the recording based on the internal clock of the sensor device.
Instructions for Use – NightOwl ® Sensor – Healthcare Professional Page 11 of 24