Troubleshooting - Bissell 1699 SERIES - 120V User Manual

Troubleshooting

WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
SmartTemp Ready Light does not illuminate.
Possible Causes
The SmartTemp switch is not
turned ON.
The machine Power Switch is not
turned ON.
Reduced spray or no spray
Possible Causes
Bladder may be empty.
SmartMix bottle may be empty.
The filter may be clogged.
Tanks may not be seated properly.
Pump may have lost prime.
The Pump Belt may be broken.
Lift Here
Insert
Screwdriver
Blade Here
DirtLifter PowerBrush does not turn.
Possible Causes
The Brush Belt or Pump Belt
may be broken.
Remedies
Turn on the SmartTemp switch.
Both switches must be ON to
activate the SmartTemp Ready Light.
Remedies
Refill tank with hot tap water.
Fill with BISSELL Deep Cleaning
Formula for cleaning or water if rinsing.
Clean out Flow Indicator Filter, page 18.
Turn power OFF; remove & reseat tanks.
Turn power OFF; after 1 minute turn ON
and depress trigger.
Turn the machine OFF and unplug from
the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into
the lower slot of the Belt Access door
to release the lower snap. If necessary,
insert the blade end into the upper slot
to release the upper snap. Examine the
belt for breakage. You should be able
to see the Pump Belt looped around
the motor shaft. If it is broken or
missing, please refer to Replacement
Parts on page 23 before calling
Consumer Services. Complete
installation instructions will
accompany the replacement belt.
Remedies
Turn the machine OFF and unplug from
the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into
the lower slot of the Belt Access door
to release the lower snap. If necessary,
insert the blade end into the upper slot
to release the upper snap. Examine the
belt for breakage. If broken refer to
pages 19-20.
21