Freeze damage prevention (Continued)
Check that the POWER LED on
3
the main display is lit up.
Resupplying the Water
Open the shutoff valve.
1
Check that water is not leaking from a pipe
or the top unit.
If the power is not turned ON
2
insert it.
(Page 15)
Switch the breaker on the
distribution board to ON.
(Asia, Oceania, Middle East)
Discharge water from the wand.
3
(1) Pressing down the left side of the toilet seat,
(2) Press the "REAR" on the remote
control to discharge water from the
wand. (Catch the water in a paper cup
or other receptacle)
■ If the remaining water has frozen
and no water comes out
Heat the inside of the bathroom, and warm
the water supply hose and shutoff valve
using a cloth soaked in warm water.
4
(Page 15)
■ To use the NEOREST again
The water needs to be replenished. (See below)
(After draining)
4
5
Set the toilet seat temperature
to "High".
(Page 24)
(To maintain the temperature.)
When fi nished, close the toilet seat and toilet lid.
Press [FLUSH] on
the remote control to
fl ush.
If there is no water in the
tank, you cannot fl ush the
toilet. Never operate the
toilet with no water in the
tank.
When the tank is fi lling with
water, the LED on the main
display will fl icker. After
the tank is full, the LED
changes. (Tank fi lling time:
approx. 30 seconds)
After the bowl unit
fi lls with water, press
[FLUSH] again.
55