Unit Identification - LG AR-DR12-05A Installation And Operation Manual

Receiving
Upon receiving the product, check to ensure all items are accounted for by referencing the delivery receipt or packing list. Inspect each crate
or carton for shipping damage before accepting delivery. Alert
the carrier of any damage detected. The customer will make notation of damage (or shortage of items) on the delivery receipt and all copies
of the bill of lading which is countersigned by the delivering carrier. If damaged, immediately contact your manufacturer's representative. Any
physical damage to the unit after acceptance is not the responsibility of the manufacturer.
Unpacking
If unit is to be installed, tested and operated right away, locate and remove all packing materials from the furnace, including any protective
coverings that may be on the combustion air intake and on the furnace exhaust. Follow Unpacking Instructions as found in the unit-specific
IOM.
Storage
If unit must be stored after it is received, take steps to protect furnace from damage, moisture, and extreme temperatures. Verify that gas
piping is plugged.

Unit Identification

It is necessary to know the unit model number, the burner control turndown and the serial number. This information is needed when ordering
replacement parts and is available on labels located on the unit.
Furnace Model Number
On the furnace access door or immediately next to the door is a Mylar data label. See image below. Locate the furnace model number at the
top of the label and record it here:
Furnace Model Number: _______________________________
INDIRECT GAS FIRED FURNACES
Figure 31: Typical Furnace Data Label
Model
Number
Minimum Input
BTU/HR
Input
BTU/HR
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
65