Table of Contents
Advertisement
Installation
Step 4-Handlebar Remote Install
1.
Cut zip tie retaining handle bar wires [L].
2.
Locate factory integrated harness connector
and remove protective cap [M].
3.
Mount the switch assembly [N] to handlebar
location as shown.
4.
With the switch mounted, attach the switch
plug [O] to the integrated plug [M], and install
a new zip tie at location [L].
Step 5-Reinstall
1.
Turn your ATV ignition on and test the winch
operation.
2.
On the EXT, 450 and 570 re-assemble the
center cover [A] from step 1.2 and close the
front rack.
3.
On the 850 and 1000 models re-assemble the
front rack.
4.
On all models, re-install the front lower cover,
front clip on the scramblers and any aftermar-
ket bumpers removed from steps 3 and 4.
ASP-35
N
L
O
M
9
Advertisement
Table of Contents
