Table of Contents
Advertisement
MODEL #SE25 – 2,500LB (1134KG) WINCH
Mount the Contactor
5.
Find a location for the contactor. If the model
specific mounting kit does not indicate a
recommended contactor location, then it is
recommended that the contactor be mounted close
to the battery in a clean dry location. Be certain the
location you choose allows for sufficient clearance
form all metal components. Drill mounting holes
if required. Once a location is found, do not install
until all wiring is completed.
Install Handlebar Mounted
Mini Rocker Switch
6.
The Handlebar Mounted Mini Rocker Switch is
normally installed on the left handlebar.
7.
Use electrical tape wrapped around the handlebar
to prevent rotation of the switch mounting brackets.
Do NOT tighten over any hoses or cables.
8.
Once your switch is mounted you can route wires
back to the contactor location.
9.
Splice the end of the red wire to an ignition
controlled (keyed) power source using the supplied
wire splice. You may need to use a test light or
multimeter to locate a suitable wire. The wire
should only have power when the key is in the ON
position.
Mount the Hand Remote Socket
(optional, sold separately)
10. Determine a mounting location for the Hand Remote
socket. Be certain the area behind the selection
location is clear.
11. Drill three holes as shown in the following figure
and install using supplied hardware. You can also
use the rubber cap attached to the remote socket
as a template.
1.69 in. [42.5mm]
1.0 in.
[25 mm]
.84 in.
[21.3 mm]
12. Once your remote socket is mounted, you may
route wires back to the contactor location.
13. Splice the end of the red wire to an ignition
controlled (keyed) power source using the supplied
wire splice. You may need to use a test light or
multimeter to locate a suitable wire. The wire
should only have power when the key is in the ON
position.
14. Secure the wires with supplied cable ties.
6
ASSEMBLy
3/16 in.
[5 mm]
Not to Scale
DO NOT Use
as a template.
Advertisement
Table of Contents
