Siemens SINAMICS G120 Getting Started page 43

Table 4- 3 Set jogging
Parameter Description
p1058 Jog 1
p1059 Jog 2
Table 4- 4 Selecting the fieldbus protocol
Parameter Possible settings (selection options, depend on the CU type)
p2030 0: No protocol (this means: Control via digital inputs/connecting terminals)
1: USS
2: Modbus
3: PROFIBUS DP
4: CAN
5: BACnet
7: PROFINET
8: P1
Table 4- 5 Set the USS interface
Parameter Description
p2020 Set the baud rate
Value
4
5
6
7
p2022 Fieldbus interface USS PZD number
Sets the number of 16-bit words in the PZD part of the USS telegram
Setting range: 0... 8 (0 ... 8 words)
p2023 Fieldbus interface USS PKW number
Sets the number of 16-bit words in the PKW part of the USS telegram
Setting range:
0, 3, 4: 0, 3 or 4 words
•
127:
•
Table 4- 6 Setting the ramp-function generator
Parameter Description
p1080 Minimum speed in [rpm]
p1082 Maximum speed in [rpm]
p1120 Ramp-up time of the motor after switching on in [s]
p1121 Ramp-down time of the motor after switching off in [s]
Converter with Control Units CU230P-2; CU240B-2; CU240E-2
Getting Started, 04/2014, A5E32885834B AB
Baud rate
2400
4800
9600
19200
variable length
Value Baud rate
8 38400
9 57600
10 76800
11 93750
Commissioning
4.3 Commissioning
Value Baud rate
12 115200
13 187500
43